ACI406/407
Mifare card reader

Description

ACI406/407 ATS1105 ATS1170

ATS1250

Connection

Cable

J2

J1

Door 1, 2, 3, 4

8-30V Power supply

Blanc

12V

12V

12V

0V Connection to reader

Rose

0V

0V

0V

Clock connection to reader

Vert

D0

D0

D0

Data connection to reader

Bleu

D1

D1

D1

Reader LED - Green

Gris

-

L1

L1

Reader LED - Red
Reader beeper

ACI406

jaune

-

L2

L2

Marron

-

L2

BZ

ACI407

Mifare Card reader
The ACI406/407 Reader is a Mifare card reader (compatible with the ARITECH ACT400 card). It is designed, for example, to mount on metal, window or door frames and is suitable for any location that requires a small reader.
The ACI407 is equipped with a keypad for Card+PIN applications.
The ACI406/407 incorporates all interface electronics necessary to interface with the ATS1105, ATS1170 and ATS1250.

READER WIRING (REFER TO

)

Note: The ACI406/407 power link must be set to +12 volts. Wire colours are an indication only and may vary depending on the type of data cable used. Use the WCAT 54 Data cable, 50 metres maximum. data cable back to the ATS1105, ATS1170 and ATS1250. The
2
separate Earth wire must be at least 2.5mm . A heavier gauge is recommended for runs of over 500 metres.
The "GND" link must remain fitted.
The ACI406/407 must not be connected to a local earth.

INSTALLING
If readers are placed closer than 10 cm from each other or if the reader is installed on metal, the reading distance can be shorter.
Do not install close to sources of powerful electromagnetic disturbance. Do not cut the cable shorter than 10 cm.

EARTHING
The earth terminals on every piece of equipment in the system that is housed in a metal base, must be earthed by connecting them all to one common earth point via a separate Earth wire run with the

Lecteur de carte Mifare
Les lecteurs ACI406/407 sont des lecteurs de cartes